Helmut

Forum Replies Created

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • in reply to: new decal install question on ti frame #6726
    Helmut
    Member

    I would recommend you acetone. I have used it for my Fat Chance bikes and even with my IF ti deluxe. Works great. Good luck and Merry Christmas

    Helmut

    in reply to: Weight Limit #5419
    Helmut
    Member

    no problem Darren. I know the problem with the corroded set tubes already from the Yo Eddy. In the pictures shown above are some very fancy water drains. Thank God that I did not have these problems with my IF ti deluxe. I’ll post some pictures when the If is ready to travel. Incidentally, it is the baby blue frame of Kingroon with the Chris Igleheart that I’ll build up.

    in reply to: Weight Limit #5403
    Helmut
    Member

    The frame has no rust inside. I removed the bottom bracket. The threads in the bottom bracket are like new. I have protected my whole IF and Fat Chance bikes with Fat Mike Sanders or fluid film corrosion protection against rust.

    in reply to: New Decals #4988
    Helmut
    Member

    Hi,

    my new decals arrived today. Thanks for the quick delivery. Now I can decorate my IF Deluxe ti again. I would never get the idea to provide any other No Name bike with Independence Fabrication stickers. Only where the name Independent Fabrication is on it, should also be an Independent Fabrication bike. So do not worry that I'm using the decals on a no name bike. Once I installed the decals I will send you some pictures to prove that I'm put them on my ti deluxe.

    Many greetings from Germany

    Helmut

Viewing 4 posts - 1 through 4 (of 4 total)

Trackback URL

Built by Asteriskr | Powered by Wordpress | Served by Aegishosting | RSS Feed | Twitter Feed | Log in |

© 2004-2013 Independent Fabrication Owners' Club: All text and images copyright unless otherwise stated